This Travertine cleaning Alton project was in a lovely cottage in the beautiful village of Upper Farrington near Alton in Hampshire
Our client called for our travertine restoration services because she could not keep her Travertine floor clean. The tiles had holes that were filling with dirt, and she could not get the grout lines clean.
Dirty holes are a common problem with honed and filled travertine.
Travertine has a honeycomb structure, like cinder toffee. The honeycomb structure means that in some places the surface of the tile can be as thick as an eggshell.
As the ties start to wear, these weak areas become thinner, eventually collapsing to reveal the underlying hole. The holes can vary from small pores to large craters. It is impossible to stop the holes filling with soil. Eventually, there are dirty holes all over the floor.
As you can see in this photograph, there were some large holes in the floor on this travertine cleaning Alton project.
Travertine Dirty Grout
Dirty grout is a common problem with tile and stone floors. Grout gets dirty because sand based grout has a rough surface like sandpaper. The rough finish can be tough to clean. Mopping with a cotton mop adds to the problem because the mop moves dirty slurry into the grout. The dirty sludge starts to damage the grout, making it even more porous. It is like a never-ending circle. This is exactly what has happened with this travertine cleaning alton project.
The grout lines on this floor were quite wide, so the dirty grout lines made the whole floor look dull.
We started by cleaning the larger holes with diamond burrs. As we worked, we also cleaned out any damaged filler. Then filling the large holes with hard travertine filler. We use adhesive tape around the holes to make grinding easier and quicker.
The travertine filler is a two-pack process with a filler and a chemical hardener. Once the filler had solidified, we ground the filler smooth with the surface of the stone.
The picture above shows two large hole repairs after filling and smoothing.
Grout Filling Small Holes In Travertine
Small holes are too small and too numerous to fill with a hard filler. So we scrubbed the floor with a strong cleaner to help emulsify the ingrained soil. Then we used our high-pressure hot rinse equipment to lift the emulsified soil away from the floor.
Our cleaning also removed any loose filler that was likely to fall away in the coming months.
We filled the remaining holes with a fine jasmine coloured grout.
Once the grout had dried, we removed any grout haze off the tiles ready for sealing.
Sealing The Travertine Tiles
We sealed the floor with a water based acrylic mid-sheen sealer. We recommended this sealer on our travertine cleaning Alton project because the travertine sealer will help to protect the surface of the tiles from damage. The sealer sits on top of the stone, acting as the wear layer, protecting remaining areas of thin tile against premature collapse. The sealer also makes the grout lines and grout filler much easier to clean.
Maintenance Cleaning Travertine Tiles
We recommend to sweep the floor once or twice a day, using a dry microfiber mop. Then damp mopping the floor daily with a specialist cleaner that contains a small amount of sealer, helping maintain the finish.
With correct maintenance, the finish can last four years. You can extend the life of the finish by topping up the sealer every 6 to 12 months with a new layer of sealer.
If you need your travertine looking clean and beautiful again, please contact me for a free no-obligation quotation for travertine restoration.
Learn more here http://www.abbeyfloorcare.co.uk/travertine/travertine-cleaning-alton-hampshire-gu34/
No comments:
Post a Comment